Owner Manual

5
Step 6: Mark and Drill Track Holes
a.Line up a Track on the line and mark the location of the holes. Note: holes are 16”
apart, line up with wall studs if possible.
b.Concrete wall: Drill holes by using a 1/4”concrete drill bit.
c.Wood framed wall: Drill out the holes by using a drill with 5/32” drill bit.
Concrete wall
Wooden wall
Step 7: Install The Track
Using the Spacers, Long Lag Screws, and Washers (and hollow wall anchor if
necessary), attach the Track to the wall as shown in the illustration below.
Tip: Loosely attach one end of the Track with the other end resting on the ground.
Then swing track up and attach other end. Finally, fill in the middle holes.
door height + 1-3/8”
16”
16”
16”
16”
②Spacer
②
①hollow wall anchor
①
③Washers
③
④Long Lag Screws
④
④
③
②