User Manual

6
Add Device
• Go to the Yeelight App homepage and click “+” in the upper right corner to add
your device.
• Proceed with the configuration as instructed on the App.
• Once you’ve added a device successfully, you can find it in the device list.
Note: The operation procedure may differ from what’s described here due to App
updates. Please proceed as instructed on the App.
This product can also be controlled on Mi home, Google Home App, and Amazon Alexa.
You can download and install one of these Apps from an App store, and configure your
device as instructed on the App. After you have finished the configuration, you can use
the App to control the light.
Restore to factory settings
Use the switch to turn the light bulb on and off five times (on for two seconds and off for
two seconds). The light bulb will start to change colour or brightness alternately and
automatically change to white light with full brightness after five seconds. This indicates
that light bulb has been restored to its factory settings.
Warnings
• Before using this product, please make sure that your voltage is appropriate for
this product’s working voltage. Using this product with a voltage other than the
one specified may damage the product and cause safety hazards.
• Do not disassemble this product, as the light diodes can cause damage to the
eyes.
• The light bulb will heat up when working. Do not use it in a conned holder for an
extended period of time. Ensure sufficient ventilation for the light bulb to allow
for heat dissipation.
• For indoor use only.
• Disconnect power before installation to prevent risk of electronic shock.
• Use in Dry Locations only.
• For lamps with a weight significantly higher than that of the lamps for which they
are a replacement, attention should be drawn to the fact that the increased
weight may reduce the mechanical stability of certain luminaires and lamp
holders and may impair contact making and lamp retention.
• Under normal use of condition, this equipment should be kept a separation
distance of at least 20cm between the antenna and the body of the user.