Specifications

- 52 -
3-10 Front axle installation
1. Insert the front wheel axle on the right side and tighten b BOLT, FLG to 85 Nm on
the left side.
2. Without preliminary tightening, fully tighten the bolts in the sequence pinch bolt 2,
pinch bolt 1 and pinch bolt 2 to 10 Nm.
3. Check that the axle head end is flush with the fork side end (at D), and if it is not,
make them flush applying external force by hand or a plastic headed hammer.
4. Without preliminary tightening, fully tighten the bolts in the sequence pinch bolt 4,
pinch bolt 3 and pinch bolt 4 to 20 Nm.
CAUTION :
Pay attention to the direction of installation of the wheel assembly.
Apply grease to the
seating surface
Pinch bolt 4
Pinch bolt 2
Pinch bolt 1
Pinch bolt 3