Specifications

°
7
1.4.5 - Resume of camshaft setting stages
 Fitting the angle disc so that 0° of the scale indicate piston Top Dead Centre
• Reach roughly TDC and set 0mm on the TDC dial gage
• Check disc angle symmetrically when piston is 2mm down Before and After TDC
• Re-adjust disc position if necessary
 Setting exhaust camshaft
• Reach maximum exhaust valve lift and set 0 mm on the dial gage
• Measure crankshaft angle position when valve is symmetrically 2mm down from maximum lift
• Calculate camshaft event angle
• Adjust camshaft event angle if necessary
• Measure valve to piston clearance
• Re-adjust camshaft event angle if necessary
 Setting intake camshaft
• Reach maximum intake valve lift and set 0 mm on the dial gage
• Measure crankshaft angle position when valve is symmetrically 2mm down from maximum lift
• Calculate camshaft event angle
• Adjust camshaft event angle if necessary
• Measure valve to piston clearance
• Re-adjust camshaft event angle if necessary