User manual

MyPBX-SOHO User Manual
www.yeastar.com Page 8
managing, maintaining and operating.
Plug Ethernet line into MyPBX’s Ethernet port, and then connect the other
head of Ethernet line with hub, switch, router, LAN or WAN. Check the status
of LED after connection, yellow light indicates port is in connecting process,
green light indicates the port is in working.
2.3 Connecting Power
MyPBX utilizes the high-performance switch power, which supply the
enough voltage and electrical energy that required by MyPBX system.
AC Input: 100~240V
DC Output: 12V,5A
Note: Prior to connect power, it’s better to use the three-phrase power
outlet of neutral-point joint or multi-function computer power outlet.
Please follow the below steps to connect power socket:
1. Push the switch on ‘OFF’ on power outlet.
2. Connect one head of the accessory power cable with the power input port
on MyPBX’s back panel, and plug the other head of power cable into 220V
power socket.
3. Push the switch on ‘ON’ on power outlet.
4. After wired up power, please check the Power LED on front panel whether
it lighted or not. Lighted LED indicates the correct operation of power; if
unlighted, please repeat the step 1 to 3 again.