Installation guide

MyPBX U520 Installation Guide
http://www.yeastar.com 14/14
Step 4: Reboot the IP terminal after configuration, and click “Status Monitor”->”Line Status” on the menu bar
of MyPBX web configuration interface to check if it has registered successfully to MyPBX.
4.6 Making/Receiving calls
Note: The MyPBX default settings are sufficient to make phone calls. It is not necessary to make any changes
unless the user wants to create new extensions or trunks. Refer to Administrator’s Guide for more.
1. Internal calls between extensions
If two IP terminals have registered to MyPBX successfully, the user could make calls between extensions
just by dialing the other’s extension number.
2. Outbound calls
Firstly, please connect a PSTN line to the first FXO port. Then the default extensions are able to make
outbound calls via this trunk by simply dialing “9+phone number+#”. The “#” is Key as Send.
Note: The dial pattern of the default outbound route is “9.”. But if the user has changed it, please dial the
new prefix instead of the digit “9” when making outbound calls.
3. Inbound calls
When the user calls the trunk number of the PSTN line, MyPBX would route the call to IVR (the “welcome”
prompt) by default. Then the user can dial the extension number following the prompt.
4.7 Reset to Factory Defaults
If you forget the new IP address or the password of admin, or in other cases that you would like to restore
the factory defaults, please reset the device following the below instructions:
Please press the “RESET” button located in the back panel with a paper clip or a pencil tip, then you can see
all of the LED indicators in the front panel would all turn red first and turn orange seconds later. When the
indicator light becomes orange, the button could be released and system begins to reset. During the process,
please do not power off until the LED indicators become normal which means the reset process is completed.
Note: After resetting, all the configurations made by the admin would be erased.
5. Conclusion
This Installation Guide only explains the installation and basic settings of MyPBX U520 for making and
receiving calls. For more functionality and advanced settings of MyPBX U520, please refer to the relative
documents as below:
“MyPBX U520 Datasheet”
“MyPBX U520 Administrator’s Guide”
“MyPBX U520 User’s Guide”
[The End]