User manual

MyPBX Standard User Manual
www.yeastar.com Page 36
Users can check their voice mail by dialing *2 on their phone (*2 is default
setting, but it can be changed on the Feature Codes page).
·Attended Transfer
Users may transfer an incoming call by dialing *3 on their phone (*3 is default
setting, but it can be changed on the Feature Codes page).
·Blind Transfer
Users may blind transfer an incoming call by dialing *03 on their phone (*03 is
default setting, but it can be changed on the Feature Codes page).
·Call Pickup
Users may pick up an incoming call by dialing *4 on their phone (*4 is default
setting, but it can be changed on the Feature Codes page)
·Pickup a specific extension
Users may pick up a specific extension’s incoming call by dialing *04+extension
number on their phone (*04 is default setting, but it can be changed on the
Feature Codes page)
·Intercom
Define the feature code that is used to dial an extension in intercom mode. For
instance setting this value to *5 would allow you to initiate an intercom call with
extension 501 by dialing *5501.
2. Call Park Preferences
·Call Park
User may park an incoming call on his own telephone by pressing ‘*6’ (*6 is
default setting)
·Call Parking on other extension
User may park an incoming call on a designated extension at first and then pick
up the call again on any other extension.
·Call Parking Duration
The maximum duration that allowed parking a call, in seconds.
3. Call Forward Preferences
·Reset to defaults
Users may reset all call forward defaults by calling *70 on their phone (*70 is
default setting, but it can be changed on the Feature Codes page).
Note: When the Reset to defaults feature is used, the call forward default
values will be set as follows:
Always forward: Disabled
Busy forward to voice mail: Enabled
No answer forward to voice mail: Enabled
Do not disturb: Disabled
·Enable always forward
Users may enable always forward by calling *71 on their phone (*71 is default