Installation guide

MyPBX U5XX Administrator's Guide
www.yeastar.comPage32
We can reset or reboot MyPBX U5XX via web directly in this page.
Figure 5-19 Reset and Reboot Options
·Reboot System
Warning: Rebooting the system will terminate all active calls!
·Reset to Factory Defaults
Warning: A factory reset will erase all configuration data on the system.
Please do not turn off the system until the RUN light begins blinking. Any power
interruption during this time could cause damage to the system.
5.3.6 Hot Standby
Redundancy is achieved by using duplicate hardware and software installations
and synchronizing data and operating state. Redundancy assures smooth
operation even if a system goes down. Essentially a duplicate backup system
takes over with virtually no loss of service. This technique assures absolute
reliability no matter what failure occurs. In mission critical installations,
redundancy is a way to address possibility of any failure.
Note 1: Before enabling the Hot Standby feature, please make sure that the
two servers in the failover pair are the same model, own the same modules
installed in the same slots, the same hardware configurations and firmware
version.
Note 2: Please configure the primary server first and configure the secondary
server only after the running status of primary server becomes “active”.
Note 3: The virtual IP address inputted in this page will be the one used for
registering in each IP phone.
Note 4: Before configuring the Email list in this page, please configure
the “voicemail settings” in “PBXBasic settings”, and make sure the SMTP test
successfully.
Note 5: Before configure the SMS list; please make sure the SIM and
GSM/UMTS modules are installed well