Installation guide

MyPBX U300 Installation Guide
http://www.yeastar.com 5/13
Figure 2-3 MyPBX U300 Rear Panel
LED
Indication
Status
Description
Power
Power status
On
The power is switched on
Off
The power is switched off
RUN
MyPBX status
Blinking
MyPBX is running properly
Not Blinking/Off
MyPBX goes wrong
Ports
Description
RJ11 ports
FXS port: For the connection of analog phones.
Ethernet ports
MyPBX U300 provides two 10/100M adaptive RJ45 Ethernet ports, marked as LAN and
WAN.
-LAN port: LAN port is for the connection to Local Area Network (LAN).
-WAN port: WAN port is the network port for the connection to internet. It supports ‘DHCP
server’, ‘PPPoE/dynamic DNS’, and “static IP” for IP address assignment.
E1/T1 ports
For the connection to E1 line or the E1 port of traditional PBX.
Audio Input
port
For the connection to a music-on-hold source
Audio output
port
For the connection to a paging system.
Reset Button
Press the reset button to restore the factory defaults
Please make sure that you’d like to reset because once reset, the previous
configurations would be erased automatically.
Power port
For the connection of a power adapter to input 100~240V、50~60HZ AC power
USB port
Console port
For debugging
2.3 Specifications and Operating Environment
Description
Size
L213 * W 160 * H 44 (mm)
Power Supply
220V,50～60Hz