Installation guide

MyPBX U300 Administrator's Guide
www.yeastar.com Page9
2.2 Connecting Ethernet Line
MyPBX provides two 10/100MEthernet ports with RJ45 interface and LED
indicator. Plug Ethernet line into MyPBX‟s Ethernet port, and then connect the
other end of the Ethernet line with a hub, switch, router, LAN or WAN. Once
connected, check the status of the LED indicator. A yellow LED indicates the port
is in the connection process, and a green LED indicates the port is properly
connected.
2.3 Supplying Power
Please follow the steps below to connect the MyPBX unit to a power outlet:
1. Connect the small end of the power cable to the power input port on the
MyPBX back panel, and plug the other end of the cable into a 100V~240V
AC power outlet.
2. Check the Power LED on the front panel. A solid green LEDindicatesthat
power is being supplied correctly.