Specifications

MyPBX SOHO Administrator Guide
92/204
N: Any Digit from 2-9
[12345-9]: Any digit in the brackets (in this example, 1, 2, 3, 4, 5, 6, 7, 8, 9)
The “.” Character will match any remaining digits. For example, “9011.” will match any
phone number that starts with “9011”, excluding “9011” itself.
The “!” will match none remaining digits, and causes the matching process to complete as
soon as it can be determined that no other matches are possible.
Example 1: NXXXXXX will match any 7-digit phone number.
Example 2: 1NXXNXXXXX will match a phone number starting with a 1, followed by a
3-digit area code, and then 6-digit number.
For more information, please refer to Appendix F How to Use DID.
·Extension
Define the extension for DID number. This field is only valid when you use BRI, SIP, SPS
or SPX trunk for this inbound router. You can only input number and “-” in this field and the
format can be xxx or xxx-xxx. The count of the number must be only one or equal to the
count of the DID number.
·Caller ID Number
Define the Caller ID Number to be matched on incoming calls. Leave this field blank to
match any or no DID info.
You can also use a pattern match (e.g. 2[345]X) to match a range of numbers.
The following patterns may be used:
X: Any Digit from 0-9
Z: Any Digit from 1-9
N: Any Digit from 2-9
[12345-9]: Any digit in the brackets (in this example, 1, 2, 3, 4, 5, 6, 7, 8, 9)
The “.” Character will match any remaining digits. For example, “9011.” will match any
phone number that starts with “9011”, excluding “9011” itself.
The “!” will match none remaining digits, and causes the matching process to complete as
soon as it can be determined that no other matches are possible.
Example 1: NXXXXXX will match any 7 digits phone number.
Example 2: 1NXXNXXXXX will match a phone number starting with a 1, followed by a
3-digit area code, and then 6-digit number.
·Distinctive Ringtone
MyPBX support mapping to custom ring tone files. For example, if you configure the
distinctive ringing for custom ring tone to “Family”, the ring tone will be played if the phone
receives the incoming call.
·Enable Callback
You can enable the callback function of this inbound route. If you want to configure the