Specifications

MyPBX SOHO Administrator Guide
42/204
·Name
A character-based name for this user, e.g. “Bob Jones”.
·Caller ID
The Caller ID (CID) string will be used when this user calls another internal user.
2) Voicemail
·Enable Voicemail
Check this box if the user should have a voicemail account.
·Voicemail Access PIN #
Voicemail Password for this extension, e.g. “1234”.
3) Mail Setting
·Enable Send Voicemail
Once enabled, the voicemail will be sent to the email address below as an attachment.
·Send Voicemail to Email Address
This option defines whether or not voicemails/Fax is sent to the Email address as an
attachment.
Note: Please ensure that all voicemail settings are properly configured on the System
Settings -> Voicemail Settings page before using this feature.
4) Flash
·Hook Flash Detection
Sets the amount of time, in milliseconds, that must pass since the last hook-flash event
received by MyPBX before it will recognize a second event. If a second event occurs in
less time than defined by Hook Flash Detection, then MyPBX will ignore the event. The
default value of Flash is 1000ms, and it can be configured in 1ms increments.
5) Group
·Pickup Group
If this extension belongs to a pickup group, any calls that ring this extension can be picked
up by other extensions in the same pickup group by dialing the Call Pickup feature code
(the default is *4).
Note: *4 is the default setting, it can be changed under Feature Codes -> General -> Call
Pickup.
6) Call Duration Settings
Setup the max cull duration for every call of this extension, but it’s only valid for outbound
calls. Enter “0” or leave this blank empty, the value would be equal to the max call duration
configured in the Option Settings page.
Note: this setting will not be valid for internal calls.