User manual

IP Intercom
IS710-P(W) could be installed to internet according to the below steps.
2.1 Embedded
If the product is used for embedding,then the cutting of embedded need to be a little
bigger than the installing hole of standard dimension 168*116*42mm .(42mm means the
extra aluminum housing thickness.),as follows. Notice: the embedded value is up to the
actual situation.
2.2 Equipment installation
1
、
Open the aluminum housing.
2、built in the IP intercom according to the cutting embedded specification. after built-in,
www.escene.cn/en
ESCENE Communication CO. LTD.