Quick Start Guide

The software upgrade is only supported by the operating system of 64-bit Windows 10.
Resetting UVC80/UVC50 Camera to Home Position
1. Tap to enter the Camera Control page.
2. Tap
Reset .
Procedure
Controlling UVC80/UVC50 Camera Position
1. Tap to enter the Camera Control page.
2. Tap or to zoom camera in/out.
3. Tap / / / to pan/tilt the camera.
Procedure
Upgrading System Software through Windows Update
Enabling Automatically Windows Update
1. On the display screen, navigate to ->Settings.
2. Enter the administrator password (default: sfb) to access Setup screen.
3. Navigate to Windows Settings->Go to Admin Sign-in.
4. Select Administrator from the bottom-left corner and then enter the administrator password
(default: sfb).
5 . Tap the Start button, and then go to Settings->Upgrade & Security->Windows Update , and
select Advanced options .
6. Enable Automatically download updates, even over metered data connections
(charge may apply) .
The system software(including the Windows, the UVC80/UVC50, the MTouch and the MShare)
can be automatically upgraded via windows update by default. Otherwise, you can enable
automatically windows update or upgrade the devices manually.
Manually Windows Update
1. On the display screen, navigate to ->Settings.
2. Enter the administrator password (default: sfb) to access Setup screen.
3. Navigate to Windows Settings->Go to Admin Sign-in.
4. Select Administrator from the bottom-left corner and then enter the administrator password
(default: sfb).
5. Do one of the following:
Long tap the Start button, and then select
Device Manager .
Select the desired device and then long tap the device to select Update driver .
Select a desired way to update.
Tap the Start button, and then n
avigate to Settings->Upgrade & Security->Windows Update ,
and select Check for updates .
Select the desired device and then complete the installation.
3