Operation Manual

User Guide for the W56P IP DECT Phone
76
5. Click Confirm to accept the change.
Note
To set up a network conference call via the handset:
1. Place a call to the first party.
2. Press the Options soft key, and then select Conference.
3. Do one of the following:
- Enter the number of the second party or select the handset you want to add to the
conference.
Press , , or the Conf. soft key to dial out.
- Press the Directory soft key, and then select the desired contact.
Press , , or the Call soft key.
If both the office number and the mobile number of the contact are stored, select the
desired number and then press , , or the OK soft key to dial out.
4. When the second party answers the call, you can consult with him or her before adding the
call to the conference.
5. Press the Conf. soft key again to add the new party to the conference.
6. Repeat steps 2 to 5 until you add all intended parties.
To invite another party into an active conference call via the handset:
Any party in the conference call can invite another party into an active conference call. Before
the following steps, ensure that an active conference call has already existed on your IP DECT
phone.
1. Press the New Call soft key.
2. Enter the desired number using the keypad.
3. Press , or to dial out.
4. When the new party answers the call, press the Options soft key, and then select
Conference.
The new party is joined to the conference call.
To place the active conference call on hold via the handset:
1. Any party in the conference call can press the Options soft key, and then select Hold.
The party will only place himself/herself on hold. Other parties can continue the conference
call normally. The conference call will only be held when all parties in the conference call
place themselves on hold.
To end the conference call on the IP phone via the handset:
1. The conference initiator presses or the End soft key.
Network Conference is only configurable via the web user interface.