Operation Manual

Phone Settings
61
Auto Intercom
Intercom is a useful feature in an office environment to quickly connect with the operator or the
secretary. You can make internal intercom calls and external intercom calls on the phone.
Internal intercom calls are made between handsets registered to the same base station. External
intercom calls can be made by dialing the feature access code followed by the number. External
intercom calls depend on support from a SIP server.
The handset can automatically answer an incoming external intercom call and play warning tone
only when there is only one handset subscribed and no call in progress on the handset.
To automatically answer an incoming internal intercom call, you need to enable auto intercom
feature on the handset. The following configuration types of auto intercom feature are available
for selection:
 On (Beep On): Auto intercom feature is on. The handset will answer an incoming internal
intercom call automatically and play a warning tone.
 On (Beep Off): Auto intercom feature is on. The handset will answer an incoming internal
intercom call automatically without a warning tone.
 Off: Auto intercom feature is off. You need to answer an incoming internal intercom call
manually.
To configure auto intercom via the handset:
1. Press to enter the main menu.
2. Select Settings->Telephony->Auto Intercom.
The LCD screen displays three configuration types.
3. Press or to highlight the desired configuration type.
4. Press the Change soft key.
The radio box of the selected configuration type is marked.
For more information on placing an internal call, refer to Placing Internal Calls on page 66.
Base Restart
In some instances, you may need to restart the base station to refresh the settings.
To restart the base station via the handset:
1. Press to enter the main menu.
2. Select Settings->System Settings->Base Restart.
3. Enter the system PIN (default: 0000), and then press the Done soft key.
After the above steps, the registration LED and network status LED go out simultaneously. After
a period of time, the LED indicators will illuminate solid green again when the base station
restarts successfully.
Base restart is also configurable via the web user interface at the path: Settings->Upgrade.