Operation Manual

User Guide for the W56P IP DECT Phone
58
As the configuration shown above, you can do the following:
- For Line 1: Line 1 (1023) is assigned to Handset2. A call to line 1 (1023) will be received by
Handset2.
- For Line 2: Line 2 (104) is assigned to Handset3. A call to line 2 (104) will be received by
Handset3.
- For Line 3: Line 3 (1045) is assigned to Handset1 and Handset2. A call to line 3 (1045) will
be received by Handset1 and Handset2 at the same time. The handsets ringing
simultaneously, the incoming call can be only answered by one of them.
To assign the incoming line to handsets via the handset:
1. Press to enter the main menu.
2. Select Settings->Telephony->Incoming Lines.
3. Enter the system PIN (default: 0000), and then press the Done soft key.
The LCD screen displays all handsets registered to the base station. The handset itself is
highlighted and followed by a left arrow.
4. Press or to highlight the desired handset, and then press the OK soft key.
5. Press or to select Accept from the desired line fields.
6. Press the Save soft key to accept the change.
7. Press the Back soft key to return to the previous screen.
8. Repeat steps 4-7 to assign incoming lines for other handsets.
Key As Send
You can set the “#” key or “*” key to perform as a send key while dialing.
To configure key as send via web user interface:
1. Click on Features->General Information.
2. Select the desired value from the pull-down list of Key As Send.
3. Click Confirm to accept the change.