Operation Manual

User Guide for the W56P IP DECT Phone
56
Outgoing Lines
After the handset is registered to the base station (refer to Handset Registration), you can assign
one or more outgoing lines for the handset. The handset can only use the assigned outgoing
line(s) to place calls. When multiple outgoing lines are assigned to the handset, the handset uses
the first line as the default outgoing line. You can change the default outgoing line of the
handset.
To assign the outgoing line to specific handset via web user interface:
1. Click on Account->Number Assignment.
2. Check the desired checkbox of the account from Line No.&Name field for the
corresponding handset in the Handset No. field.
3. (Optional.) Select the default outgoing line from the Default field. The default outgoing line
is the first line you selected. You can only select the line number you have checked for the
handset, or it will not take effect.
4. Click Confirm to save the change.
As the configuration shown above, you can do the following:
- For Handset1: Line 3 (1045) is assigned to Handset1, and it is the default outgoing line. You
can only place a call using line 3 (1045).
- For Handset2: Line 1 (1023) and line 3 (1045) are assigned to Handset2, and the default
outgoing line is line1. You can place a call using line 1 (1023) or line 3 (1045).
- For Handset3: Line 2 (104) is assigned to Handset3, and it is the default outgoing line. You
can only place a call using line 2 (104).
- Both Handset 1 and Handset 2 can place a call using the line 3 (1045) at the same time.