Operation Manual

User Guide for the W56P IP DECT Phone
54
3. Enter the desired line ID in the Account field or leave it blank.
For more information on the valid values for the Account field, refer to Replace Rule on
page 50.
4. Click Confirm to accept the change.
Note
Block Out
You can block some specific numbers (up to 10) from being dialed. When you dial the block out
number on the handset, the dialing will fail, and the LCD screen will prompt “Forbidden”.
To add a block out number via web user interface via the handset:
1. Click on Settings->Dial Plan->Block Out.
2. Enter the desired value in the BlockOut NumberX field.
3. Enter the desired line ID in the Account field or leave it blank.
For more information on the valid values for the Account field, refer to Replace Rule on
page 50.
The default values of minimum and maximum lengths are 1 and 15.
Area code is configurable via web user interface only.
Area code is applicable to all the handsets registered to the base station.