Operation Manual

User Guide for the W56P IP DECT Phone
36
5. Press or to select the desired value from the Low Battery field.
6. Press the Save soft key to accept the change or the Back soft key to cancel.
Note
Backlight
Handset backlight status in the charging state or out of the charging state can be configured
independently of each other. If enabled, the backlight is always on. Otherwise, the backlight is
turned off after the handset is idle for a period of time. But the backlight is automatically turned
on when an incoming call arrives, a key is pressed or the status of handset changes. You can
disable the backlight to save power.
To configure the backlight via the handset:
1. Press to enter the main menu.
2. Select Settings->Display->Display Backlight.
3. Press or to select the desired value from the In Charger field.
4. Press or to select the desired value from the Out Of Charger field.
5. Press the Save soft key to accept the change or the Back soft key to cancel.
Screen Saver
The screen saver of the handset is designed to protect your LCD screen by filling it with an
analog clock. You can enable the screen saver to protect the LCD screen if you do not use your
handset for a long time. When the screen saver is enabled, an analog clock will be activated and
appear on the LCD screen if the handset is idle for approximately 10 seconds.
To configure screen saver via the handset:
1. Press to enter the main menu.
2. Select Settings->Display->Screen Saver.
3. Press the Change soft key to check or uncheck the Screen Saver checkbox.
Wallpaper
You can change the wallpaper image to display when the handset is idle.
To change the wallpaper via the handset:
1. Press to enter the main menu.
2. Select Settings->Display->Wallpaper.
If the silent mode is activated, the advisory tones will not play, but you can still see the low
battery and confirm information alert on the LCD screen. For more information on the silent
mode, refer to Switching Silent Mode to On/Off on page 31.