Operation Manual

Basic Operations

The keypad is unlocked and the icon disappears from the idle screen.

Note

Switching Silent Mode to On/Off

If the silent mode is switched to On, the handset will not ring when receiving an incoming call,

but you can still see the incoming call information on the LCD screen. You can switch the silent

mode to On if you do not want to be disturbed.

To switch the silent mode to On via the handset:

1. Long press until the LCD screen prompts “All Ring Tones Off”.

The silent mode is on. The icon appears on the status bar.

To switch the silent mode to Off via the handset:

1. Long press again until the LCD screen prompts “All Ring Tones On”.

The silent mode is off. The icon disappears from the status bar.

Note

Locating a Handset

You can locate a misplaced registered handset using the base station.

To locate a handset via the handset:

1. Press on the base station.

All the handsets that are registered to this base station will ring (paging) simultaneously

and display the IP address of the base station on the LCD screen.

This helps you locate your handset easily.

You can press any key on one of the handsets or press again on the base station to end

ring (paging).

You can also locate handsets via web user interface at the path

Status->Handset&VoIP->Paging Status.

If the keypad is locked, only the emergency numbers can be dialed out. You must enter the

emergency number continuously and completely. To place emergency calls, you should configure

the emergency numbers in advance. For more information, refer to Emergency Numbers on page

55.

When the silent mode is activated, the advisory tones will not be played, regardless of their

settings.