Operation Manual

User Guide for the W56P IP DECT Phone
6
To connect the PoE:
1. Connect the Ethernet cable between the Internet port on the base station and an available
port on the in-line power switch/hub.
Note
Setting up the W56H Handset
To insert battery into the handset:
1. Open the battery cover.
2. Insert the battery and press it down.
3. Close the battery cover.
Note
If in-line power is provided, you don’t need to connect the AC adapter. Make sure the switch/hub
is PoE compliant.
Important! Do not remove the power and network to the base station while it is updating
firmware and configurations.
Do not short-circuit the battery, as short-circuiting the terminals may damage the battery or the
handset.
Do not use a damaged battery, as this may cause an explosion.
Before replacing the battery, please turn off the handset to prevent memory loss.