User Guide

Getting Started
37
3. Enter the desired value in the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS field respectively.
4. Press the Save soft key to accept the change or the Back soft key to cancel.
You can configure a static IPv6 address for the Skype for Business phone, make sure that the IP
mode is configured as IPv6or IPv4 & IPv6.
To configure a static IPv6 address via phone user interface:
1. Press ->Advanced (default password: admin) ->Network->WAN Port->IPv6.
2. Press or , or the Switch soft key to select the Static IP from the Type field.
3. Enter the desired value in the IP Address, IPv6 IP Prefix, Gateway, Primary DNS and
Secondary DNS fields respectively.
4. Press the Save soft key to accept the change or the Back soft key to cancel.
If you are using an xDSL modem for IPv4 network connection, you can connect your phone to
the Internet via PPPoE mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a
PPP negotiation to obtain the IP address. Contact your system administrator for the PPPoE user
name and password.
To configure PPPoE via phone user interface:
1. Press ->Advanced (default password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select the PPPoE from the Type field.