User Guide

User Guide for the SIP-T41S IP Phone
26
Push Button Configuration (PBC)
To connect to the wireless network using PBC method:
1. Press Menu->Settings->Basic Settings->Wi-Fi.
2. Press the WPS soft key, and then select WPS.
The LCD screen prompts “WPS has been activated, connect in 120s!”.
3. Long press the WPS key on your gateway/router.
Once WPS setup has completed successfully, the icon appears after the name of
wireless network.
Personal Identification Number (PIN)
To connect to the wireless network using PIN method:
1. Press Menu->Settings->Basic Settings->Wi-Fi.
2. Press the WPS soft key, and then select WPS-PIN.
The LCD screen prompts “Please input below PIN code on your Wi-Fi router and press OK
to connect: xxx”.
3. Log into your gateway/router’s web interface, and configure it to search the clients. For
more information, refer to the documentation from the gateway/router manufacturer.
Once WPS-PIN setup has completed successfully, the gateway/router’s web interface will
prompt success.
Note
Manually Add a Wireless Network
If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results.
In that case, you must manually add a wireless network.
To add a wireless network:
1. Press Menu->Settings->Basic Settings->Wi-Fi.
2. Press or to highlight Known Network(s), and then press the Add soft key.
3. Use the WLAN settings obtained from your gateway/router to configure this WLAN Profile
on the IP phone. Do the following:
a) If you select None or WEP from the pull-down list of Security Mode:
Enter the profile name, SSID and WPA shared key in the corresponding fields.
b) If you select WPA-PSK or WPA2-PSK from the pull-down list of Security Mode:
Select the desired Cipher type (TKIP, AES or TKIP AES) from the pull-down list of
Cipher Type.
Enter the profile name, SSID and WPA shared key in the corresponding fields.
Contact your gateway/router provider for more information.