User Manual

Configuration Guide for User Access Level

Application

This section will introduce procedures to configure access permission of the web user interface

in detail. The flow chart of configuring user access level is shown as below:

Note: The boot file is only applicable to IP phones running firmware version 81 or later. The

parameter varies from firmware version to firmware version (refer to Configuring Yealink IP

Phones).

Upload the boot file (e.g., y000000000000.boot) to the directory of the

provisioning server.

Edit the boot file (e.g., y000000000000.boot):

1. Reference the configuration file in the boot file (e.g., include: config

“ftp://<ServerIPAddress>/features.cfg”).

1. 2.

Settings take effect after phone reboot. You can login the web user interface

with different access levels to check the settings.

Trigger the IP phone to perform auto provisioning.

Upload the configuration file (e.g., y000000000028.cfg, features.cfg) to the

directory of the provisioning server.

Edit the configuration file (e.g., y000000000028.cfg, features.cfg):

1. Set the value of parameter “static.security.var_enable” to 1.

2. Configure the value of the parameter “static.web_item_level.url”.

(e.g., ftp://<ServerIPAddress>/WebItemsLevel.cfg)

Upload the WebItemsLevel.cfg file to the directory of the provisioning server.

Edit the desired configuration items in the Yealink-supplied template file

“WebItemsLevel.cfg”.