User Manual

Configuration Guide for User Access Level

Parameters

Permitted Values

Default

HTTPS download URL

Description:

This parameter is used to configure the access URL of the WebItemsLevel.cfg file.

Note: It takes effect after reboot.

Web User Interface:

None

Phone User Interface:

None

The parameter settings in the configuration file for reference are shown as below:

static.security.var_enable = 1

static.web_item_level.url = ftp://192.168.1.100/WebItemsLevel.cfg

static.security.default_access_level = 1

2. Upload the configuration file to the directory of the provisioning server.

3. Reference the configuration file in the boot file (e.g., y000000000000.boot).

include:config “ftp://192.168.1.100/features.cfg”

4. Upload the boot file to the directory of the provisioning server.

5. Configure the access URL of the provisioning server for the IP phone.

6. Trigger the IP phone to perform auto provisioning.

The boot file is only applicable to IP phones running firmware version 81 or later. For more

information on auto provisioning Yealink IP phones, refer to

Yealink_SIP-T2 Series_T19(P)

E2_T4_Series_IP_Phones_Auto_Provisioning_Guide_V81

When the user access level is enabled, you can login the web/phone/handset user interface with

different access levels.

To login the web user interface with different access levels:

1. Press the OK/√ key when the phone is idle to obtain the IP address.

For W56P, press the OK->Status->Base to obtain the IP address.

2. Enter the IP address (e.g., http://192.168.0.10 or 192.168.0.10) in the address bar of web

browser on your PC and then press the Enter key.

3. Enter the user name (admin/var/user) and password (admin/var/user) in the login page.

4. Click Confirm to login.