User Manual

Configuration Guide for User Access Level
18
Configuring Yealink IP Phones
User access level feature is disabled for Yealink W56P/SIP
VP-T49G/SIP-T48G/T48S/T46G/T46S/T42G/T42S/T41P/T41S/T40P/T29G/T27P/T27G/T23P/T23G
/T21(P) E2/T19(P) E2/CP860 IP phones in neutral firmware version by default. Before using this
feature, you need to enable it through auto provisioning introduced as following. User access
level feature is configurable only via configuration files.
To configure user access level feature for Yealink IP phones:
1. Edit the following parameters in the configuration file (e.g., y000000000051.cfg).
Parameters
Permitted Values
Default
security.var_enable
0 or 1
0
Description:
This parameter is used to enable or disable the login of the web/phone/handset user
interface with different access levels.
0-Disabled
1-Enabled
Note: It takes effect after reboot.
Web User Interface:
None
Phone User Interface:
None
security.default_access_level
0, 1 or 2
0
Description:
This parameter is used to configure the default access level to access the
phone/handset user interface.
0-user
1-var
2-admin
Note: It works only if the value of the parameter “security.var_enable” is set to 1
(Enabled). It takes effect after reboot.
Web User Interface: