Specifications

Administrator’s Guide for SIP-T2xP IP Phones
30
3. Mark the desired radio box.
If you mark the As Router radio box, you can configure the IP address for the PC
port and configure DHCP for the PC attached to the PC port.
1) Enter the IP address in the IP Address field.
2) Enter subnet mask in the Subnet Mask field.
3) Select the desired value from the pull-down list of Enable DHCP Server.
4) Enter the start IP address in the Start IP Address field.
5) Enter the end IP address in the End IP Address field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after reboot.
5. Click OK to reboot the IP phone.
To configure the PC port mode via phone user interface:
1. Press Menu->Settings->Advanced Settings (password: admin) ->Network->PC Port.
2. Select the desired mode.
If you select Router, you can configure the IP address for the PC port and configure
DHCP for the PC attached to the PC port.
1) Enter the IP address in the IPv4 field.
2) Enter the subnet mask in the Subnet Mask field.
3) Press or to highlight the DHCP Server field, and then press the Enter soft
key.
4) Select the desired value from the Server Status field.
5) Enter the start IP address in the Start IP field.
6) Enter the end IP address in the End IP field.
3. Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of
time.