Specifications

Administrator’s Guide for SIP-T2xP IP Phones
24
To configure the IP address mode via phone user interface:
1. Press Menu->Settings->Advanced Settings (password: admin) ->Network->WAN
Port.
2. Press or to select IPv4, IPv6 or IPv4&IPv6 from the IP Mode field.
3. Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of
time.
To configure a static IPv4 address via phone user interface:
1. Press Menu->Settings->Advanced Settings (password: admin) ->Network->WAN
Port->IPv4->Static IP Client.
2. Enter the desired values in the IPv4, Subnet Mask, Default Gateway, Pri DNS and Sec
DNS fields.
3. Press the Save soft key to accept the change.
The IP phone reboots automatically to make settings effective after a period of
time.
Note
PPPoE
PPPoE (Point-to-Point Protocol over Ethernet) is a network protocol used by Internet
Service Providers (ISPs) to provide Digital Subscriber Line (DSL) high speed Internet
services. PPPoE allows an office or building-full of users to share a common DSL
connection to the Internet. PPPoE connection is supported by the IP phone Internet
port. Contact your ISP for the PPPoE user name and password.
Procedure
PPPoE can be configured using the configuration files or locally.
Configuration File
<y0000000000xx>.cfg
Configure PPPoE on the IP
phone.
For more information, refer to
PPPoE on page 254.
Local
Web User Interface
Configure PPPoE on the IP
phone.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network&q=load
Using the wrong network parameters may result in inaccessibility of your phone and may
also have an impact on your network performance. For more information on these
parameters, contact your network administrator.