User Guide

User Guide for the SIP-T29G IP Phone
148
Blind Transfer
Before performing a blind transfer (except you use dial number method), make sure that the
transfer mode on DSS key is configured as Blind Transfer. For more information on how to
configure it, refer to Configuring Transfer Mode on DSS Key on page 171.
To perform a blind transfer during a call:
1. Press or the Transfer soft key during a call.
2. You can do one of the following:
- Enter the number you want to transfer the call to.
Press or the Transfer soft key to complete the transfer.
If you are using a handset, the transfer can be completed by hanging up the handset.
- Press the Directory soft key, and then select Local Directory. Select the desired
group and search for the contact (Directory should be configured in advance. Refer to
Directory on page 61 for more information).
Press , or the Send soft key to complete the transfer.
- Press the Directory soft key, and then select History. Select the desired list and then
press or to select the entry (Directory should be configured in advance.
Refer to Directory on page 61 for more information).
Press , or the Send soft key to complete the transfer.
- Press the Directory soft key, and then select Remote Phone Book. Select the desired
group and search for the contact (Directory should be configured in advance. Refer to
Directory on page 61 and Remote Phone Book on page 79 for more information).
Press , or the Send soft key to complete the transfer.
To perform a blind transfer to exist call:
1. Press or the Transfer soft key during a call.