User guide

Yealink IP Phones Auto Provisioning Guide
150
Parameter
Permitted
Values
Descriptions
Web Setting Path
The default value is 2.
transfer.multi_call_trans_enable
(not applicable to SIP-T48G/T46G/T29G IP phones)
0 or 1
It enables or disables the IP phone to select
transferee‘s call (a new call or another
existing call) during multiple calls when user
presses the Tran/Transfer soft key or
TRAN/TRANSFER key.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the user can select to
transfer the active call to a new call or
another existing call during multiple calls
when the user presses the Tran/Transfer soft
key or TRAN/TRANSFER key.
If it is set to 0 (Disabled), the user can transfer
the active call to a new call during multiple
calls when the user presses the Tran/Transfer
soft key or TRAN/TRANSFER key.
The default value is 1.
Features->General Information->
Allow Trans Exist Call
transfer.tran_others_after_conf_enable
0 or 1
It enables or disables the IP phone to transfer
the local conference call to the other two
parties after the conference initiator drops the
Features->Transfer->Transfer on
Conference Hang up