Specifications

User Guide W52P IP DECT Phone

You can lock the handset keypad to prevent keys from being accidentally pressed.

To lock the keypad:

1. Long press when the handset is idle until the LCD screen prompts the

message “Keypad Locked, Press and hold „#‟ to unlock!”.

The keypad is locked and the icon appears on the idle screen.

You can still answer or reject incoming calls as usual. You can also end the

answered call by pressing .

To unlock the keypad:

1. Long press again until the LCD screen prompts the message “Keypad

Unlocked”.

The keypad is unlocked and the icon disappears from the idle screen.

Note

You can locate a misplaced handset using the base station to which the handset is

registered.

To locate a handset:

1. Press on the base station.

All handsets registered to this base station will ring simultaneously (Paging) and

display the IP address of the base station on the LCD screen.

This helps you locate your handset easily.

You can press any key on the handset or press again on the base station to

end paging.

If the silent mode is switched on, the handset will not ring when receiving an incoming

call, but you can still see the incoming call information on the LCD screen. You can switch

the silent mode on if you do not want to be disturbed.

If the keypad is locked, only the emergency numbers can be dialed out. You must enter

the digits of the emergency number continuously. To make emergency calls, you should

configure the emergency numbers in advance. For more information, refer to Emergency

Numbers on page 40.