User's Manual

UserGuideW52PIPDECTPhone
22
decrease/increasetheringervolume.
Advisory Tones
Advisorytonesareacousticsignalsofyourhandset,whichinformyouofdifferentactionsandstates.
Thefollowingadvisorytonescanbeconfiguredindependentlyofeachother:
 KeypadTone:playswhenauserpressesanykeyofthekeypad.
 Confirmation:playswhenausersavessettingsorplacesthehandsetinthechargercradle.
 LowBattery:playswhenthecapacityofthebatteriesislowandthehandsetrequirescharging.
Toconfiguretheadvisorytones:
1. Presstoenterthemainmenu.
2. Select‐>Audio‐>AdvisoryTones.
3. Press   or   toselectthedesiredvaluefromtheKeypadTonefield.
4.
Press   or   toselectthedesiredvaluefromtheConfirmationfield.
5. Press   or   toselectthedesiredvaluefromtheLowBatteryfield.
6. PresstheSavesoftkeytoacceptthechangeortheBacksoftkeytocancel.
Backlight
Thehandsetbacklightstatusinthechargingstateoroutofthechargingstatecanbeconfigured
independentlyofeachother.Ifenabled,thebacklightisalwayson.Otherwise,thebacklightisturned
offafterthehandsetisidleforaperiodoftime.Butthebacklightisautomaticallyturnedon
whenan
incomingcallarrives,akeyispressedorthestatusofthehandsetchanges.Youcandisablethe
backlighttosavepower.
Toconfigurethebacklight:

1. Presstoenterthemainmenu.
2. Select ‐>Display‐>DisplayBacklight.
3. Press   or   toselectthedesiredvaluefromtheInChargerfield.
4. Press   or   toselectthedesiredvaluefromtheOutOfChargerfield.
5. PresstheSavesoft
keytoacceptthechangeortheBacksoftkeytocancel.

Screen Saver
YoucanenablethescreensavertoprotecttheLCDscreenifyoudonotuseyourhandsetforalong
time.ThescreensaverofthehandsetisdesignedtoprotectyourLCDscreenbyfillingitwithan
analogclock.Whenthescreensaverisenabled,ananalogclock
willbeactivatedanddisplaysonthe
LCDscreenifnouseractivityissensedforapproximately10seconds.