User's Manual

UserGuideW52PIPDECTPhone
14
6. EnterthevalidvaluesintheIPAddress,SubnetMask,Defaul tGateway,PrimaryDNSand
SecondaryDNSfields.
7. PresstheSavesoftkeytoacceptthechange.
IfyouareusinganxDSLmodem,youcanconnectyourbasestationtotheInternetviaPPPoEmode.
The
PPPoEportwillperformaPPPnegot iat iontoobtaintheIPaddress.Contactyoursystem
administratorforthePPPoEusernameandpassword.
ToconfigurePPPoE:
1. Presstoenterthemainmenu.
2. Select‐>SystemSettings‐>Network.
3. EnterthesystemPIN(default:0000).
4. PresstheDonesoft
key.
5. Press or toselectPPPoEfromtheIPAddressTypefield.
6. EnterthevalidvaluesinthePPPoEUserandPPPoEPasswordfields.
7. PresstheSavesoftkeytoacceptthechange.
Note
Checking System Status
Youcanviewthesystemstatusonyourhandset.Availableinformationofthesystemstatusincludes:
 Ge nera l information—includingtheIPaddress,MACaddress,firmwareversionandRFPIcodeofthe
basestation.
 Networkstatus—includingtheIPtype,subnetmask,gateway,primaryDNSandsecondaryDNS.
 Handsetstatus—includingthedevicemodel,hardwareversion,firmwareversion,productID,IPUI
codeandareaofthehandset.
Tocheckthegeneralinformation:
1. Presstoenterthemainmenu.
2. Select‐>SystemStatus.
TheLCDscreendisplaysthegeneralinformationandtheMore…opti on.
3. Press or 
 toscrollthroughthelistandviewthespecificinformation.
Usingthewrongnetworkparametersmayresultininaccessibilityofyourphoneandmayalsohavean
impactonyournetworkperformance.Formoreinformationabouttheseparameters,contactyour
systemadministrator.