User's Manual

After the IP phone is connected to the network and
supplied with power, it automatically begins the
initialization process. After startup, the phone is ready
for use. You can configure the phone via web user
interface or phone user interface.
WelcomeWelcome
Configuring Your Phone
1. Tap ->Status when the phone is idle to obtain the IP address of the phone.
2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10"
or "192.168.0.10"), and then press Enter.
3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm.
Network Settings: Click on Network->Basic->IPv4 Config
Static IP Address: If the phone cannot contact a DHCP server for any reason, you need to configure IP address,
subnet mask, gateway address, primary DNS address and secondary DNS address for the
phone manually.
Register Status: It shows the register status of the current account.
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
Register status icons on the LCD screen:
Note: Check with your system administrator if any error appears during the registration process or a specific
configuration is required for your registration.
Configuring via phone user interface
4
Startup
Accessing the web user interface:
Account Settings: Click on Account->Register ->Account X (X=1,2,3...15,16)
Parameters of the account:
Registering
Registered
Register Failed
(Green)
(Gray) (Green and Flashing)
When the phone is idle, tap ->Advanced (default password: admin)->Account to configure the account.
Configuring via web user interface
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode.
Contact the ITSP for the user name and password.
You can configure the network settings in the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid network
settings, e.g., IP address, subnet mask, gateway address and DNS address.
Server Host:
It is an authenticated ID for authentication provided by ITSP (required).
Display Name: It is shown as Caller ID when placing a call.
Line Active: You can select Enabled/Disabled to enable/disable the account.
Register Name:
User Name:
Password:
Account Settings:
Network Settings:
When the phone is idle, tap ->Advanced (default password: admin)->Network->WAN Port/VLAN/Web Server/802.1x/ VPN/ LLDP
/CDP/NAT to configure the network.
Label: It is shown on the LED screen to identify the account.
Note: The IP phone also supports IPv6, but IPv6 is disabled by default.