User's Manual

User Guide for the SIP-T48G IP Phone
20
1. Open the web browser on your computer.
2. Enter the IP address in the browser’s address bar, and then press the Enter key.
3. Enter the user name (admin) and password (admin) in the login page.
4. Click Confirm to login.
The phone status is displayed on the first page of the web user interface.
$CUKE0GVYQTM5GVVKPIU
If your phone cannot contact a DHCP server for any reason, you need to configure
network settings manually. The IP phone can support either or both IPv4 and IPv6
addresses.
To configure the IP address mode via phone user interface:
1. Press Menu->Advanced (password: admin) ->Network->WAN Port.
2. Press or to select IPv4, IPv6 or IPv4 & IPv6 from the IP Address Mode field.
3. Press the Save soft key to accept the change or the Back soft key to cancel.
To configure a static IPv4 address via phone user interface:
1. Press Menu->Advanced (password: admin) ->Network->WAN Port->IPv4.
2. Press or , or the Switch soft key to select the Static IP from the Type field.
3. Enter the desired values in the IP Address, Subnet Mask, Gateway, Primary DNS and
Secondary DNS fields respectively.