User Manual

Getting Started

Procedure

PC port mode can be configured using the configuration files or locally.

Configuration File

<y0000000000xx>.cfg

Configure the PC port mode.

For more information, refer to PC

Port Mode on page 266.

Local

Web User Interface

Configure the PC port mode.

Navigate to:

http://<phoneIPAddress>/servlet

?p=network-pcport&q=load

Phone User Interface

Configure the PC port mode.

To configure the PC port mode via web user interface:

1. Click on Network->PC Port.

2. Select the desired value from the pull-down list of PC Port Active.

3. Mark the desired radio box.

If you mark the As Router radio box, you can configure the IP address for the PC port

and configure DHCP for the PC attached to the PC port.

1) Enter the IP address in the IP Address field.

2) Enter subnet mask in the Subnet Mask field.

3) Select the desired value from the pull-down list of Enable DHCP Server.

4) Enter the start IP address in the Start IP Address field.

5) Enter the end IP address in the End IP Address field.

4. Click Confirm to accept the change.

A dialog box pops up to prompt that settings will take effect after a reboot.

5. Click OK to reboot the IP phone.