User Manual

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones

Local

Web User Interface

Configure the transmission

methods of Ethernet ports.

Navigate to:

http://<phoneIPAddress>/servlet

?p=network-adv&q=load

To configure the transmission methods of Ethernet ports via web user interface:

1. Click on Network->Advanced.

2. Select the desired value from the pull-down list of WAN Port Link.

3. Select the desired value from the pull-down list of PC Port Link.

4. Click Confirm to accept the change.

The PC port on the back of the IP phone is used to connect a PC, which can be

configured in one of two modes:

 Bridge: The IP phone functions as a bridge, and the connected PC appears on the

network as a stand-alone device with its own IP address.

 Router: The IP phone functions as a router, and provides a DHCP service for the

connected PC.

Note

The router mode is not applicable to SIP-T19P and SIP-T21P IP phones.