User Manual

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
154
Procedure
Configuration changes can be performed using the configuration files or locally.
Configuration File
<y0000000000xx>.cfg
Assign a multicast paging key.
For more information, refer to
Multicast Paging Key on page
419.
Specify a multicast codec for the
IP phone to use for multicast RTP.
For more information, refer to
Sending RTP Stream on page 351.
Local
Web User Interface
Assign a multicast paging key.
Navigate to:
http://<phoneIPAddress>/servlet
?p=dsskey&q=load&model=0
Specify a multicast codec for the
IP phone to use for multicast RTP.
Navigate to:
http://<phoneIPAddress>/servlet
?p=features-general&q=load
Phone User Interface
Assign a multicast paging key.
To configure a multicast paging key via web user interface:
1. Click on DSSKey->Memory Key (or Line Key).
2. In the desired DSS key field, select Multicast Paging from the pull-down list of Type.
3. Enter the multicast IP address and port number in the Value field.
The valid multicast IP addresses range from 224.0.0.0 to 239.255.255.255.
4. Click Confirm to accept the change.