User Manual

5 / 14

FIG 6 YDLIDAR F4PRO DRIVER INSTALLATION PROCESS

After the installation is complete, you can right-click on My Computer and select Properties. On the

Open system interface, select Device Manager from the left menu to enter the device manager and

expand Ports. The serial port name corresponding to the identified USB adapter is the driver

installation successful. The following figure shows COM3. (Note that the port must be checked with

F4PRO and PC interconnected)

Note: The user can also select Type-C on the F4PRO to quickly get started and use the Type-C data cable to

connect the PC and F4PRO directly. After downloading the VCP serial driver of F4PRO on the official website,

after the installation is successful, start PointCloud Viewer to scan the map, and then you can observe the point

cloud data.