Manual

12 / 12

Restart [A5 80]

When an external device sends a command (A5 80) to F4PRO, F4PRO will enter a soft reboot and

the system will restart. This command does not answer.

Standby control

The F4PRO integrates the power control of the system into the command interface of the system, not

the hardware interface. Therefore, the user only needs to send the corresponding control command

(A5 01/02) to enable/disable the low-power state of the system.

Motor speed control

The F4PRO integrates the speed control of the system into the command interface of the system, not

the hardware interface. The user can change the speed of the motor by adjusting the scan frequency.

USE CAUTION

When interacting with the F4PRO, commands other than the scan command (A5 65) cannot be

exchanged in the scan mode. Otherwise, the packets may be parsed incorrectly.