User's Manual

Notebook-PC adapter card (WL2400-PCM)

You can insert the card into notebook-PC while the power is on or

off.

1. Insert the adapter card into the PCMCIA slot.

2. If the notebook PC is not already on, power it up.

Normally, Windows will automatically detect the new hardware and

prompt you for the drivers. Install the device driver following the

instructions in the Software Installation section.

3.3 Software Installation

The following instructions should be used presuming that you have some networking

experience. If not, you may have some trouble understanding and networking your

computers.

3.3.1 Windows 95/98 Driver Setup

1. After you install the WL2400-PCM or -ISA, a wizard will appear to guide you through the

installation process. Click “Next” and then “Have Disk” or “Specify Location”.

2. Type “a:\win9598” at the Location prompt. Click “OK”. If the driver is in the right location,

click “Finish”. The program may request files from the Windows 95/98 CD-ROM; make

sure you have it nearby or already in the CD-ROM.

3. When a window appears requesting the location of the file “pcmbn3.sys” or “itcmd.vxd”,

type “a:\win9598”.

4. Restart your computer when prompted.