User Manual

Marquee™ Point-to-Point Series User Guide
10. The Marquee is optimized for a transmit rate of 24 Mbps and the transmit power is preset from facto
with the proper value.
ry
1. Click the Network ID button. The corresponding screen appears (see Figure 3.7). Select a number
2. Click
13. Click the System Access button. The corresponding screen appears (see Figure 3.8). Enter a Pass
Phrase to identify the wireless network. Both units in a link must be configured with the same Pass
Phrase value. Click OK.
Figure 3.7 – TurboCell Advanced Setup Screen Figure 3.8 – System Access Setup
Network ID
1
from 0 through 15 to identify your network. Both units in a link must be configured with the same
Network ID value.
1 OK. Click OK again.
Figure 3.9 – Save Configuration
15. After the Marquee has finished saving its
configuration, exit the Configurator program.
The Marquee is ready to use. Refer to the
Marquee Series Configuration Guide,
available as a pdf file on your CD ROM, or the
online help for complete instructions on setting
up other features in the unit.
14. Go to File and click Save Config: this will save
the new settings (see Fig. 3.9).
Version 1.2 Page 18 February 2005