User Manual

Marquee™ Point-to-Point Series User Guide
6. After you login successfully, the Setup screen appears. Click on the IP Host button. The IP Setup
ss.
. Back to the S e Setu appears
(see Figure
Figure 3.4 – Interface Setup Screen
screen appears (see Figure 3.3). Enter the IP Address, Subnet Mask, and Default Router IP Addre
Click OK.
7 etup screen, click on the Interfac p button. The corresponding screen
3.4).
Figure 3.3 – IP Setup Screen
8 Click on Setup 2. The IEEE 802.11 Setup . screen appears (see Figure 3.5). Select the type of Station
this Marquee is going to be. In a P-P configuration one unit must be Base and the other must be
9. Click the Advanced button. The corresponding screen appears (see Figure 3.6). Select a Frequency
C units in a link mus
frequency value.
Figure 3.5 – IEEE 802.11 Interface Setup Screen Figure 3.6 – TurboCell Advanced Setup Screen
Remote (Satellite). Radio Configuration must be set to 802.11a. Leave the rest of the buttons
unchanged.
hannel from the pull down menu box. Both t be configured with the same
Version 1.2 Page 17 February 2005