User Manual

Marquee™ Point-to-Point Series User Guide
3.3 Configuring the Marquee
The Marquee is shipped from factory pre-c and with the proper transmit power
settings. The units are set with the following default IP addresses:
198.17.74.251 and 198.17.74.252
ome of the parameters that you may need to change are the following:
nnec
2. Double- open the directory where the
Configu s\Configurator) and run the
program
3. The Ma To scan for devices on the network, place the cursor
anywhe evices box and right-click the mouse. A Re-scan local network
button w f devices will appear.
. Click on the device you wish to configure. The selected device IP address will appear in the text box
e Marquee
unit). Click this button.
5.
afe
place.
onfigured for operation
Marquee Bridge P-P (2 each):
The default read/write password is public.
S
• IP addresses
• Read/Write password
• Radio frequency channel
1. Co t a crossover Ethernet cable from the Cat 5 DC Power Injector to your laptop or PC.
click the Configurator shortcut on your desktop. You may also
rator program has been installed (the default is \Program File
config.exe.
in Screen shown in Figure 3.1 appears.
re in the List of Scanned D
ill appear. Click on the button. A list o
4
above the Configure Remote button (alternatively, you can enter here the IP address of th
A Read/Write Password text box will appear (see Figure 3.2). The default password is public. Click
the OK button. It is suggested that you change the password later, write it down and keep it in a s
Figure 3.1 – Configurator Main Screen Figure 3.2 – Login Screen
Version 1.2 Page 16 February 2005