User Manual

Marquee™ Point-to-Point Series User Guide
Figure 2.10 – Plugging the Outdoor Ethernet Cable
2. Attach the other end of the outdoor Ethernet cable to ctor at port RJ-45
labeled “To Antenna.”
3. Connect the Ethernet cabl PC/Router” r Injector into a regular
port on your router, switch or hub. If you connect to a computer or PC, use a cross-over cable or
adapter.
4. Perform an Earth ground connection to any of the rear bolts of the unit, the mounting brackets, or the
mast (if metallic). For maximum protection, also connect the metal wire of the surge protected DC
Injector to ground as shown on Figure 2.11.
Figure 2.11 – Installation of the Terabeam Surge d DC Injector
for Maximum Grounding Protection
5.
the Cat 5 DC Power Inje
e labeled “To from the Cat 5 DC Powe
Protecte
If you are using a Marquee unit with an external antenna, connect the antenna to the N-type female
jack on the back of the unit.
RJ-45 Ethernet Connector
To Switch, Router or PC
To Marquee
Surge Protected
DC Injector
AC Power
Power Supply
Ground Wire
Plug the connector into the jack by
aligning the notch with the tab
Caution not: Be sure DC Power is
when
p
lu
gg
in
g
the c
applied
able
If DC Power is applied while you are attempting to insert the round
effort to find the key, DC power pins will momentarily touch the Ethernet
pins. Ethernet circuitry on the board will be
dama lso, do not apply excessive pressure when you insert the
round connector or the pins will pop out. Any damage caused by this
action will
not
connector into the jack, it is possible that, as you rotate the plug in an
If this happens the
ged. A
be covered by the factory warranty and will be a billable
repair.
WARNING
Version 1.2 Page 9 February 2005