User Manual

Marquee™ Point-to-MultiPoint Series User Guide
3. Turn the pivot adaptor bracket (B) so that the rectangular part is parallel with the surface of the
Marquee P-MP FP. Fasten the Marquee P-MP unit to the pole using pole clamp (C), U-bolt (D), and
two nuts, as shown in Fig 2.5. Tighten hardware (two places). The pole clamp (C) and U-bolt (D) will
accept pole diameters between 0.75” to 1.5” OD.
Figure 2.5 – Attaching the Marquee P-MP FP Unit to the Pole
(D)
(B)
(C)
Min 0.75”
Max 1.5”
(A)
Proceed to Section 2.7 – Cabling the Marquee P-MP (All Enclosures).
2.6 Hardware Installation – EX Enclosure
NOTE: All connectors must be properly water-proofed with all-weather electrical tape, Permagum, or
equivalent. Do not use Silicon glue.
The Marquee P-MP EX unit is installed by using an “X”-shaped adaptor bracket (A) that is secured to the
pole with a pole mounting bracket (B), and a pole clamp (C). Figure 2.6 shows the hardware provided to
mount the Marquee P-MP EX unit.
Figure 2.6 – Marquee P-MP EX Mounting Hardware
Hardware Qty
Screw Hex Head M5x20 4
(for TeraBridge 5x45 only)
Screw Hex Head M8x40 4
(for poles between 1” to 1.75” OD)
Screw Hex Head M8x70 2
(for poles between 1.75” to 3” OD)
Lock Washer M5 (with a cut) 4
Flat Washer M5 (solid) 4
Nut M5 4
Lock Washer M8 (with a cut) 4
Flat Washer M8 (solid) 6
Nut M8 2
Arm (For indoor
installations only,
not used)
“X”-Shaped Adaptor
Bracket (A)
Pole Clamp (C)
Pole Mounting
Bracket (B)
Version 1.3(a) Page 6 Jul 2005