User Manual

Marquee™ Point-to-MultiPoint Series User Guide
TABLE OF CONTENTS
Section 1 Overview 1
1.1 Description ....................................................................................................................................1
1.2 Marquee P-MP Kit Contents .........................................................................................................1
Section 2 Installation 3
2.1 Introduction ...................................................................................................................................3
2.2 DC Power Injector.........................................................................................................................3
2.3 Power Supply................................................................................................................................3
2.4 LEDs..............................................................................................................................................3
2.5 Hardware Installation – FP Enclosure...........................................................................................4
2.6 Hardware Installation – EX Enclosure ..........................................................................................6
2.7 Cabling the Marquee P-MP (All Enclosures) ................................................................................8
2.8 Antenna Alignment......................................................................................................................10
Section 3 Configuration 15
3.1 Installing the Configurator...........................................................................................................15
3.2 Basic Configuration of a Marquee P-MP.....................................................................................15
Section 4 Troubleshooting 20
4.1 Introduction .................................................................................................................................20
4.2 Cabling or Installation Issues......................................................................................................20
4.3 Configuration Issues ...................................................................................................................21
4.4 When to Contact Technical Support...........................................................................................23
Appendix A – Marquee P-MP Technical Specifications 24
PROFESSIONAL INSTALLATION REQUIRED
The Marquee P-P must be installed as a system by experienced antenna installation
professionals who are familiar with Radio Frequency (RF) issues such as gains and
losses, as well as local building and safety codes. Failure to do so will void the product
warranty and may expose the end user to excessive RF hazard.
Regulations regarding maximum antenna gains, power output and maximum permissible
exposure vary from country to country. It is the responsibility of the end user to operate
within the limits of these regulations and to ensure that the professional installers who
install this device are aware of these regulations. All antennas are intended to be installed
outdoors.
© 2005 Terabeam Wireless. All Rights Reserved. No part or parts of this document may be
reproduced, translated, stored in any electronic retrieval system or transmitted, in any form or by any
means, electronic, mechanical, photocopied, recorded or otherwise, without the prior written
permission of Terabeam Wireless.
The information in this document is subject to change without notice. Although every effort has been
made to make this manual accurate and complete, Terabeam Wireless assumes no responsibility for
any errors that may appear in this document.
The Terabeam Wireless logo is a trademark of Terabeam Wireless, Inc. Marquee is a trademark of
Terabeam Wireless, Inc. TurboCell is a registered trademark of Terabeam Wireless, Inc. All other
trademarks in this document are the property of their respective owners.
Version 1.3(a) Page ii Jul 2005