User Manual Part 2
Link CX-24 User’s Manual
Version 1.0 Page 42 February 2004
6. When the software has been FTPd to the Link CX-24, return to the Update Software page. This
process has deleted the selected software load with the new software load. Do not activate the new
software load until both ends have received their new software loads.
7. Repeat Step 1 through Step 6 of this update process for the near-end Link CX-24, and then continue
with Step 8.
8. Now that both ends of the radio link have the new software load in memory, do the following to
activate the new software load as follows:
9. Log into the far-end Link CX-24 and navigate to the Update Software page.
10. Select the new software load and click Reboot. The far-end Link CX-24 reboots and activates the
new software load.
11. Log into the near-end Link CX-24 and navigate to the Update Software page.
12. Select the new software load and click Reboot. The near-end Link CX-24 reboots and activates the
new software load. Should the radio link not be restored, make sure that both ends of the radio link
are using the same software load.
Both of the Link CX-24s on the radio link now are using the new software load and the previous
configuration parameters, and as soon as they resynchronize their signals, the radio link is restored.