User Manual Part 2
Link CX-24 User’s Manual
Version 1.0 Page 74 February 2004
STATUS mandatory
DESCRIPTION
"The IP Address of the peer radio with which this radio exchanges
Automatic Tx Power Control information."
::= { link_cx_configuration 4 }
rfChannel OBJECT-TYPE
SYNTAX INTEGER (1..2)
ACCESS read-write
STATUS mandatory
DESCRIPTION
"The current transmit channel of the local unit. The transmit
frequency in MHz for each channel can be read in the rfFrequencyTable."
::= { link_cx_configuration 5 }
rfRssiAlarmThresholdSetting OBJECT-TYPE
SYNTAX INTEGER (-80..-40)
ACCESS read-write
STATUS mandatory
DESCRIPTION
"A RSSI Alarm will be generated if the level of RSSI goes below
the set threshold. The threshold can be set in 1 dB steps
within the range of -80 to -40 dBm."
::= { link_cx_configuration 6 }
losAlarmControl OBJECT-TYPE
SYNTAX INTEGER {
enabled(1),
disabled(2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"Ethernet Loss Of Signal alarm control. When enabled, the alarm will
be generated. When disabled, the alarm will not be generated even if
LOS condition is detected."
::= { link_cx_configuration 7 }
-- link_cx_status group
rfPowerOutputLevel OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The measured radio Tx power level in dBm."
::= { link_cx_status 1 }
rfRssiLevel OBJECT-TYPE
SYNTAX INTEGER
ACCESS read-only
STATUS mandatory
DESCRIPTION
"The measured RSSI of the active channel in dBm. -110 dBm
indicates the receive signal level is below the detection level."
::= { link_cx_status 2 }